NEC TECHNOLOGIES, INC.
CDR-602
|
Device Type |
External CD-ROM |
|
Interface |
SCSI-2 |
|
Spin Rate |
6x |
|
Formats Supported Read |
CD-XA Mode 2/Form 1 & 2, CD-DA, CD-I (FMV), CD-ROM (Mode 1 & Mode 2), Video CD, Red & Yellow Book, CD-Plus, Photo CD |
|
View |
Top |
|
CONNECTIONS | |||
|
Function |
Label |
Function |
Label |
|
Analog audio out connector (Left channel) |
CN1 |
Digital audio out connector |
CN3 |
|
Analog audio out connector (Right channel) |
CN2 | ||
|
USER CONFIGURABLE SETTINGS | |||
|
Setting |
Label |
Position | |
| � |
Factory configured - do not alter |
SW2/1 |
Off |
| � |
Factory configured - do not alter |
SW2/2 |
On |
| � |
Factory configured - do not alter |
SW2/3 |
Off |
| � |
Factory configured - do not alter |
SW2/4 |
Off |
|
DRIVE SELECT ID |
|
Note: SCSI ID is selected by activating SW1 until the desired number is displayed in the viewing window. |
|
ERROR CODES | |
|
Power On Initialization Errors | |
|
On power up, if the LCD screen displays � E � or � EE �, check the following 1.If an empty caddy is inserted or partially inserted in the drive, remove it and restart the drive. 2.Turn the drive, disconnect the SCSI I/O cables and then turn the drive back on. If the problem still occurs the drive is either getting insufficent power or is broken. Check the power and if it�s good, call Tech Support. | |
|
Diagnostic Mode | |
|
To Start Diagnostic mode 1.Put any data CD into the caddy and insert the caddy into the drive. 2.Restart the drive while holding the Play/Pause button on the front panel If there are any problems the error code will be displayed in the LCD window, or if no problems are found then �ON� will be displayed | |
|
Error Codes |
Action |
|
E0 or E1 |
Make sure there is a CD in the caddy and that the caddy is fully inserted into the drive. If the problem persists, contact Tech Support. |
|
E2, E3 or E4 |
The drive is unable to read the CD. Insure that the CD in the caddy is a data CD, not a audio CD. Try another CD, to determine if the problem is limited to one disc, or the drive. If the problem persists, contact Tech Support. |
|
E5, E6 or E7 |
Possible hardware failure, contact Tech Support. |