IPTools.net.ua

Card Type

ISDN TA

Chip Set

Unidentified

I/O Options

Analog adapters (2)

Transfer Rate

56Kbps x 2/64Kbps x 2

Data Bus

16-bit ISA

ISDN Protocol

AIMux, PPP, V.120

Switch Type

5ESS, DMS-100, NI-1

Card Size

Full-height, unidentified length

CONNECTIONS

Function

Label

Function

Label

ISDN U interface

CN1

Analog adapter 2

CN3

Analog adapter 1

CN2

SUPPORTED STANDARD COMMANDS

Basic AT Commands

+++, A/

A, E, H, O, V, W, X, Z

&F, &S, &W, &Y, &Z

Extended AT Commands

\Q

S-Registers

S0, S1, S2, S3, S4, S5, S7, S10, S12, S18, S25

AUTHENTICATION PROTOCOL

Type:

Configuration

Format:

AT [cmds] @M2= x [cmds]

Description:

Selects whether the TA will use an authentication protocol.

Command

Function

@M2=N

TA will not use authentication protocol.

@M2=P

TA will use PAP authentication protocol.

COMMAND SET

Type:

Configuration

Format:

AT [cmds] @P1= n [cmds]

Description:

Selects whether the TA will use the AT command set.

Command

Function

@P1=A

AT command set enabled.

@P1=N

Command set disabled

COMMAND TARGET

Type:

Immediate

Format:

AT [cmds] >C n [cmds]

Description:

Selects which I/O interface the issued commands will target.

Command

Function

>C0

Issued commands will affect the COM port interface.

>C1

Issued commands will affect programmed I/O port 1.

>C2

Issued commands will affect programmed I/O port 2.

>C3

Issued commands will affect programmed I/O port 3.

DTR DIALING DELAY

Type:

Configuration

Format:

AT [cmds] &L2= n [cmds]

Default:

8

Range:

1 - 255

Unit:

1 second

Description:

Sets the amount of time the TA will wait between DTR dialing attempts.