DIGICOM SPA
TINTORETTO LAN
|
Card Type |
ISDN LAN |
|
Chip Set |
Unidentified |
|
I/O Options |
Power, RJ-45 connectors (4) |
|
ISDN Rate |
128Kbps |
|
Maximum Fax Rate ISDN Modulation Protocol |
14.4Kbps V.110, V.120, PPP, MLPPP |
|
Error Correction/Compression |
V.42bis |
|
Fax Class |
Class I |
|
Data Bus |
External |
|
CONNECTIONS | ||||||
|
Function |
Label |
Function |
Label | |||
|
DC power |
CN1 |
HUB LAN port (RJ-45 connector) |
CN4 | |||
|
Configuration port (RJ-45 connector) |
CN2 |
ISDN interface (RJ-45 connector) |
CN5 | |||
|
PC LAN port (RJ-45 connector) |
CN3 | |||||
|
DIAGNOSTIC LED(S) | |||
|
LED |
Color |
Status |
Condition |
|
PWR |
Green |
On |
Power is on and diagnostic test has been passed |
|
PWR |
Green |
Blinking |
Power is on. Device is in BOOT mode and is flashing EPROM |
|
PWR |
Red |
On |
Power is on. Device failed diagnostic test |
|
PWR |
Yellow |
On |
Device is loading firmware in RAM |
|
PWR |
Yellow |
Blinking |
Device is in BOOT mode |
|
PWR |
N/A |
Off |
Power is off |
|
LAN |
Green |
On |
LAN is connected and forwarding |
|
LAN |
Red |
On |
LAN connection is broken |
|
LAN |
Yellow |
On |
LAN is connected but not forwarding. |
|
B1 |
Green |
On |
ISDN B1 channel is active; in data mode |
|
B1 |
Yellow |
On |
ISDN B1 channel is active, but not compressing data |
|
B1 |
Red |
On |
ISDN B1 channel connection is being established |
|
B1 |
N/A |
Off |
ISDN B1 channel is inactive |
|
B2 |
Green |
On |
ISDN B2 channel is active; in data mode |
|
B2 |
Yellow |
On |
ISDN B2 channel is active, but not compressing data |
|
B2 |
Red |
On |
ISDN B2 channel connection is being established |
|
B2 |
N/A |
Off |
ISDN B2 channel is inactive |
|
SUPPORTED COMMAND SET |
|
Basic AT Commands |
|
AT, A/ |
|
E, Q, V, W |
|
&C, &R, &Z |
|
S Registers |
|
S3, S4, S12, S25, S26 |
|
Note: See MHI Help File for full command documentation. |
PROPRIETARY AT COMMAND SET
For a full command summary, see DIGICOM SPA TINTORETTO EXTERNAL