SEAGATE TECHNOLOGY, INC.
SIDEWINDER 200 EXTERNAL
|
Device Type |
External Tape Drive |
|
Interface |
SCSI-2 Fast/Wide |
|
Format |
AIT-1 |
|
Sustained Transfer Rate |
3MBPS (Native), 6 to 9GB (Compressed) |
|
Size |
5.25 in. half height |
|
View |
Bottom |
|
DRIVE SELECT ID |
|
Note:To select the SCSI ID, press SW1 until the ID you desire is shown in the switch viewer. The address is shown in hexadecimal. |
|
USER CONFIGURABLE SETTINGS |
|||
|
Setting |
Label |
Position |
|
|
Parity check enabled |
JP1/1 |
Open |
|
|
|
Parity check disabled |
JP1/1 |
Closed |
|
Factory configured - do not alter |
JP1/2 |
Unidentified |
|
|
Factory configured - do not alter |
SW2/1 |
Unidentified |
|
|
Factory configured - do not alter |
SW2/2 |
Unidentified |
|
|
Factory configured - do not alter |
SW2/3 |
Unidentified |
|
|
Factory configured - do not alter |
SW2/4 |
Unidentified |
|
|
Data compression enabled |
SW2/7 |
On |
|
|
|
Data compression disabled |
SW2/7 |
Off |
|
Factory configured - do not alter |
SW2/8 |
On |
|
|
MANUFACTURERS RECOMMENDED MEDIA |
||
|
Tape |
Capacity Without Compression |
Capacity With Compression |
|
AIT-1 |
100GB |
200+ GB |
|
DIAGNOSTIC LED(S) |
|||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Unidentified |
On |
Unit power is on |
|
LED1 |
Unidentified |
Off |
Unit power is off |
|
LED2 |
Green |
On |
SCSI interface is ready for data transfer |
|
LED2 |
Green |
Off |
Drive is not in use |
|
LED2 |
Green |
Blinking |
Drive is either searching for data, reading/writing to tape, or rewinding the tape |
|
LED3 |
Green |
On |
Cartridge is loaded into drive |
|
LED3 |
Green |
Blinking |
Cartridge is unloaded from drive |