TECMAR
WANGTEK 5525ES (33959-XXX)
|
Device Type |
Internal Tape Drive |
|
Interface |
SCSI-1, SCSI-2 |
|
Format |
QIC-120, QIC-150, or QIC525 (write) QIC-24, QIC-120, QIC-150, or QIC-525 (read) |
|
Sustained Transfer Rate |
200 KBPS |
|
Size |
5.25 in. half height |
|
View |
Bottom |
|
CONNECTIONS | |
|
Function |
Label |
|
Chassis ground connector |
W1 |
|
USER CONFIGURABLE SETTINGS | |||
|
Setting |
Label |
Position | |
|
Factory configured - do not alter (Built in test mode(s)) |
E2 |
Open | |
|
Factory configured - do not alter |
E3 |
Unidentified | |
|
Factory configured - do not alter (Built in test mode(s)) |
E4 |
Open | |
|
Factory configured - do not alter (48 MHz main oscillator enabled) |
E5 |
Closed | |
|
1024 byte block mode enabled |
JP2 |
Open | |
|
512 byte block mode enabled |
JP2 |
Closed | |
|
Factory configured - do not alter (Built in test mode(s)) |
JP3 |
Open | |
|
Factory configured - do not alter (Built in test mode(s)) |
JP6 |
Open | |
|
Factory configured - do not alter |
JP7 |
Unidentified | |
|
Factory configured - do not alter |
JP8 |
Unidentified | |
|
Factory configured - do not alter |
JP9 |
All pins open | |
|
Factory configured - do not alter (Built in test mode(s)) |
JP12 |
Open | |
|
Factory configured - do not alter (Diagnostic test connector) |
JP32 |
Open | |
|
DRIVE SELECT ID | ||||
|
Drive ID |
JP1/A |
JP1/B |
JP1/C | |
|
0 |
Open |
Open |
Open | |
|
1 |
Closed |
Open |
Open | |
|
2 |
Open |
Closed |
Open | |
|
3 |
Closed |
Closed |
Open | |
|
4 |
Open |
Open |
Closed | |
|
5 |
Closed |
Open |
Closed | |
|
6 |
Open |
Closed |
Closed | |
|
7 |
Closed |
Closed |
Closed | |
|
Note: Jumper JP1/D is factory configured and should not be altered. The default position for JP1/D is Open. | ||||
|
TERMINATION POWER SELECTION | ||
|
Setting |
E1 | |
|
TERMPWR supplied by drive |
Closed | |
|
TERMPWR supplied by SCSI interface to drive |
Open | |
|
Note: The fuse at F1 must be installed when TERMPWR is supplied by the drive. | ||
|
MISCELLANEOUS TECHNICAL NOTES |
|
Termination is enabled or disabled via the three removable terminating resistors (see diagram). |