FUJITSU CORPORATION
M2488
|
Device Type |
External Tape Drive |
|
Interface |
SCSI-2 Fast/Wide |
|
Format |
Unidentified |
|
Sustained Transfer Rate |
20 MBPS |
|
Size |
5.25 in. full height |
|
View |
Top |
|
DIAGNOSTIC LED(S) | |||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Unidentified |
On |
Prompts user to load the cartridge. |
|
LED1 |
Unidentified |
Off |
Cartridge is loaded |
|
LED2 |
Unidentified |
On |
Drive is selected on the SCSI bus |
|
LED2 |
Unidentified |
Off |
Drive is not selected on the SCSI bus |
|
LED3 |
Unidentified |
On |
The drive is reading/writing compressed data |
|
LED3 |
Unidentified |
Off |
The drive is reading/writing uncompressed data |
|
Note: LEDs 4 through 10 each represent the different tape positions between BOT and EOT. When the tape is moving in the forward position, the LEDs light up sequentially starting from the BOT position. When the tape is moving in reverse, the LEDs light up sequentially in the reverse order. | |||
|
MISCELLANEOUS TECHNICAL NOTES |
|
The IPM is an adapter card that is available in four different configurations: 50-pin SCSI connector (2x), 68-pin SCSI connector (2x), 50-pin SCSI connector & Terminating Resistor, 68-pin SCSI connector & Terminating Resistor. The Termination Power is supplied by the SCSI interface through pin 36. This setting is only valid with this specific IPM installed. |