TIARA COMPUTER SYSTEMS, INC.
ETHERTREK NETWORK ADAPTER JUMPER VERSION
NIC Type |
Ethernet |
Transfer Rate |
10Mbps |
Data Bus |
16-bit ISA |
Topology |
Linear Bus/Star |
Wiring Type |
Unshielded twisted pair AUI Transceiver via DB-15 port RG-58A/U 50ohm coaxial |
Boot ROM |
Available |
CABLE TYPE SELECTION | ||
Cable Type |
JP2 pins 1 & 2 |
JP2 pins 3 & 4 |
Normal unshielded twisted pair |
Open |
Open |
Reduced squelch unshielded twisted pair |
Closed |
Closed |
AUI Transceiver via DB-15 port |
Closed |
Open |
RG-58A/U 50ohm coaxial |
Open |
Closed |
BASE I/O ADDRESS SELECTION | |||
Address |
JP8 pins 1 & 2 |
JP8 pins 3 & 4 |
JP8 pins 5 & 6 |
Software |
Open |
Open |
Open |
02C0h |
Closed |
Open |
Open |
0240h |
Open |
Closed |
Open |
0280h |
Open |
Closed |
Closed |
0300h |
Open |
Open |
Open |
0320h |
Closed |
Open |
Closed |
0340h |
Closed |
Closed |
Open |
0360h |
Closed |
Closed |
Closed |
INTERRUPT SELECTION | ||||
IRQ |
JP3 pins 1 & 2 |
JP3 pins 3 & 4 |
JP3 pins 5 & 6 |
JP3 pins 7 & 8 |
IRQ3 |
Closed |
Open |
Open |
Open |
IRQ4 |
Closed |
Open |
Open |
Closed |
IRQ5 |
Closed |
Open |
Closed |
Open |
IRQ9 |
Closed |
Open |
Closed |
Closed |
IRQ10 |
Closed |
Closed |
Open |
Open |
IRQ11 |
Closed |
Closed |
Open |
Closed |
IRQ12 |
Closed |
Closed |
Closed |
Open |
IRQ15 |
Closed |
Closed |
Closed |
Closed |
LINK PULSE CONFIGURATION | |
Setting |
JP4 |
Link pulse enabled |
Open |
Link pulse disabled |
Closed |
COMPATIBILITY CONFIGURATION | ||
Setting |
JP5 pins 1 & 2 |
JP5 pins 3 & 4 |
Channel ready signal generated after command signal |
Open |
Open |
Channel ready signal generated after bus address latch |
Closed |
Open |
I/O 16-bit signal generated after I/O read or I/O write signals |
Open |
Closed |
I/O 16-bit only on address decode |
Open |
Open |
SOFTWARE/HARDWARE CONFIGURATION | |
Setting |
JP6 |
Software configured |
Closed |
Hardware configured |
Open |
BUFFERING MODE CONFIGURATION | |
Setting |
JP7 |
Memory mapped |
Open |
I/O mapped |
Closed |
MISCELLANEOUSE TECHNICAL NOTE |
Note: The JP1 Boot ROM Base address configuration is not available from the manufacturer. |