PURE DATA, LTD.
PDI8023-16T
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
16-bit ISA |
|
Topology |
Star |
|
Wiring Type |
Unshielded twisted pair |
|
Boot ROM |
Available |
|
SOFTWARE CONFIGURATION RESET | ||
|
Setting |
E1 | |
|
Normal operation |
Pins 2 & 3 closed | |
|
Reset |
Pins 1 & 2 closed | |
|
Note:Many of the options are configured using the setup utility provided with the card. To reset those configurations to the factory defaults, move E1 to the Reset position (pins 1 & 2 closed)
and apply power for a few seconds. Always make sure that you turn off the power to the
computer before you change any jumpers.
| ||
|
CARD I/D NUMBER | |||||
|
Number |
E2A |
E2B |
E2C |
E2D | |
|
1 |
Open |
Open |
Open |
Closed | |
|
2 |
Open |
Open |
Closed |
Open | |
|
3 |
Open |
Closed |
Open |
Open | |
|
4 |
Closed |
Open |
Open |
Open | |
|
Note:Up to four cards can be installed into a system at the same time. If more than one card is installed each one must have a seperate card I/D number. | |||||
|
LINK INTEGRITY TEST | ||
|
Setting |
E3 | |
|
Enabled |
Pins 1 & 2 closed | |
|
Disabled |
Pins 2 & 3 closed | |
|
FACTORY CONFIGURED SETTINGS | |
|
Jumper |
Setting |
|
E5A |
Open |
|
E5B |
Open |
|
E5C |
Closed |
|
DIAGNOSTIC LED(S) | |||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Red |
On |
Card is being accessed by host computer |
|
LED1 |
Red |
Off |
Card is not being accessed by host computer |
|
LED2 |
Green |
On |
Data is being transmitted or received |
|
LED2 |
Green |
Off |
Data is not being transmitted or received |
|
LED3 |
Red |
On |
Receive wires are reversed and corrected for |
|
LED3 |
Red |
Off |
Normal operation |
|
LED4 |
Green |
On |
Network connection is good |
|
LED4 |
Green |
Off |
Network connection is broken |
|
Note:If LED3 is lit the receive wires are reversed. The card will automatically correct for this but the wires should be repaired as soon as possible.
| |||