PURE DATA, LTD.
PDI8023-16CAT
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
16-bit ISA |
|
Topology |
Star Linear bus |
|
Wiring Type |
Unshielded twisted pair RG58A/U 50ohm coaxial AUI transceiver via DB-15 port |
|
Boot ROM |
Available |
|
SOFTWARE CONFIGURATION RESET | ||
|
Setting |
E1 | |
|
Normal operation |
Pins 2 & 3 closed | |
|
Reset |
Pins 1 & 2 closed | |
|
Note:Many of the options are configured using the setup utility provided with the card. To reset those configurations to the factory defaults, move E1 to the Reset position (pins 1 & 2 closed)
and apply power for a few seconds. Always make sure that you turn off the power to the
computer before you change any jumpers.
| ||
|
CARD I/D NUMBER | |||||
|
Number |
E2A |
E2B |
E2C |
E2D | |
|
1 |
Open |
Open |
Open |
Closed | |
|
2 |
Open |
Open |
Closed |
Open | |
|
3 |
Open |
Closed |
Open |
Open | |
|
4 |
Closed |
Open |
Open |
Open | |
|
Note:Up to four cards can be installed into a system at the same time. If more than one card is installed each one must have a seperate card I/D number. | |||||
|
LINK INTEGRITY TEST | ||
|
Setting |
E3 | |
|
Enabled |
Pins 1 & 2 closed | |
|
Disabled |
Pins 2 & 3 closed | |
|
Note:The link integrity test is only valid when the cable type is unshielded twisted pair. | ||
|
CABLE TYPE | |||||
|
Type |
E5A |
E5B |
E5C |
Isolation Transformer Location | |
|
RG58A/U 50ohm coaxial |
Open |
Closed |
Open |
T3 | |
|
Unshielded twisted pair |
Open |
Open |
Closed |
N/A | |
|
AUI transceiver via DB-15 port |
Closed |
Open |
Open |
T2 | |
|
Note:If you leave E5B closed you can select the cable type through the software setup utility included with the card. However, you must still move the Isolation transformer to the appropriate socket.
| |||||
|
SEGMENT LENGTH | ||
|
Maximum Length |
JP7 | |
|
185 meters |
Pins 2 & 3 closed | |
|
300 meters |
Pins 1 & 2 closed | |
|
Note:Segment length is the total length of cable between the two farthest cards on the segment. Each card on the segment must have this option set the same. | ||
|
DIAGNOSTIC LED(S) | |||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Green |
On |
Data is being transmitted or received |
|
LED1 |
Green |
Off |
Data is not being transmitted or received |
|
LED2 |
Red |
On |
Card is being accessed by host computer |
|
LED2 |
Red |
Off |
Card is not being accessed by host computer |