KATRON TECHNOLOGIES, INC.
KF-221TX, KF-221TX/2
|
Card Type |
Network Interface Card |
|
NIC Type |
Ethernet |
|
Maximum Onboard Memory |
Unidentified |
|
Boot ROM |
Unidentified |
|
Network Transfer Rate |
10Mbps, 100Mbps |
|
Topology |
Star bus |
|
Wiring Type |
Unshielded twisted pair |
|
Data Bus |
32-bit PCI |
|
CONNECTIONS | |
|
Function |
Label |
|
UTP connector |
CN1 |
|
NETWORK SPEED SELECTION |
|
For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3, 4, or 5 UTP cable. To establish a valid 10 Mbps connection, the cable must be connected to a 10BASE-T hub. For 100BASE-TX Ethernet networks, the Fast Ethernet adapter uses Category 5 UTP cable. To establish a valid 100 Mbps connection, the cable must be connected to a 100BASE-TX hub. |
|
DIAGNOSTIC LED(S) | ||
|
LED |
Status |
Condition |
|
LED1 |
On |
100BASE-TX connection is selected and active |
|
LED1 |
Off |
100BASE-TX connection is not selected and active |
|
LED2 |
On |
10BASE-TX connection is selected and active |
|
LED2 |
Off |
10BASE-TX connection is not selected and active |
|
LED3 |
Blinking |
Network traffic is present and is transmitting/receiving |
|
LED3 |
Off |
Network traffic is not present and is not transmitting/receiving for either speed |