LAVA COMPUTER MFG. INC.
LAVA ARCLINK
|
NIC Type |
ARCnet |
|
Transfer Rate |
2.5Mbps |
|
Data Bus |
8-bit ISA |
|
Topology |
Linear bus |
|
Wiring Type |
RG62A/U 93ohm coaxial |
|
Boot ROM |
N/A |
|
NODE ADDRESS | ||||||||
|
Node |
SW1/1 |
SW1/2 |
SW1/3 |
SW1/4 |
SW1/5 |
SW1/6 |
SW1/7 |
SW1/8 |
|
0 |
- |
- |
- |
- |
- |
- |
- |
- |
|
1 |
On |
On |
On |
On |
On |
On |
On |
Off |
|
2 |
Off |
On |
On |
On |
On |
On |
On |
On |
|
255 |
Off |
Off |
Off |
Off |
Off |
Off |
Off |
Off |
|
Note:Node address 0 is reserved and must not be used. A total of 255 node address settings are available. The switches are a binary representation of the decimal node addresses. Switch 1 is the most significant bit and switch 8 the least significant bit. The switches have the following decimal values: switch 1=128, switch 2=64, switch 3=32, switch 4=16, switch 5=8, switch 6=4, switch 7=2, switch 8=1. Turn Off the appropriate switches and add the values of the off switches to obtain the correct node address. | ||||||||
|
BASE MEMORY SELECT | |
|
Address |
SW2/1 |
|
E000h |
On |
|
D000h |
Off |
|
I/O ADDRESS SELECT | ||
|
Address |
SW2/2 |
SW2/3 |
|
2E0h |
On |
On |
|
2A0h |
On |
Off |
|
3E0h |
Off |
On |
|
3A0h |
Off |
Off |
|
FACTORY CONFIGURED SETTING | |
|
Swtich |
Setting |
|
SW2/4 |
N/A |
|
INTERRUPT SELECT | |||||
|
IRQ |
JP1 |
JP2 |
JP3 |
JP4 | |
|
IRQ3 |
Open |
Closed |
Open |
Open | |
|
IRQ2 |
Open |
Open |
Open |
Closed | |
|
IRQ4 |
Closed |
Open |
Open |
Open | |
|
IRQ5 |
Open |
Open |
Closed |
Open | |
|
DIAGNOSTICS LEDS | |||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Red |
On |
Accessing on board memory or I/O |
|
LED1 |
Red |
Blinking |
System power up |
|
LED1 |
Red |
On |
Transferring to and from the network |
|
LED2 |
Green |
On |
Transmitting to another node |
|
LED2 |
Green |
Blinking |
No node is accessable |
|
LED2 |
Green |
On |
Coax Cable connected to a active network |
|
Note:LED2 will blink at a rate based on the NODE address. If the NODE address is low, LED2 will blink at a slow rate. If the NODE address is above 128 then, LED2 will blink at a rate too high to be seen by the human eye. | |||