DANPEX CORPORATION
EN/2
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
16-bit MCA |
|
Topology |
Linear bus |
|
Wiring Type |
RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port |
|
Boot ROM |
Available |
|
CABLE TYPE | ||
|
Type |
JP2B - JP2I | |
|
RG-58A/U 50ohm coaxial |
Pins 1 & 2 closed | |
|
AUI transceiver via DB-15 port |
Pins 2 & 3 closed | |
|
ONBOARD TERMINATOR | ||
|
Setting |
JP3 | |
|
Disabled |
Pins 1 & 2 closed | |
|
Enabled |
Pins 2 & 3 closed | |
|
Note:If the card is on either end of a linear bus network segment, the onboard terminator may be used instead of an external terminator | ||
|
FACTORY CONFIGURED SETTINGS | |
|
Jumper |
Setting |
|
JP1 |
Unused |
|
JP2A |
Pins 2 & 3 closed |
|
DIAGNOSTIC LED(S) | ||
|
LED |
Status |
Condition |
|
LED1 |
On |
Data is being transmitted |
|
LED1 |
Off |
Data is not being transmitted |
|
LED2 |
On |
Collision detected on network |
|
LED2 |
Off |
Normal operation |
|
LED3 |
On |
Data is being received |
|
LED3 |
Off |
Data is not being received |