DANPEX CORPORATION
EN-9000
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
32-bit EISA |
|
Topology |
Star Linear Bus |
|
Wiring Type |
RG58A/U 50ohm coaxial Shielded/Unshielded twisted pair AUI transceiver via DB-15 port |
|
Boot ROM |
Available |
|
ACTIVITY LED ENABLE | ||
|
Setting |
JP1 | |
|
Disabled |
Pins 1 & 2 closed | |
|
Enabled |
Pins 2 & 3 closed | |
|
Note:If the network hub has an activity LED for each line, setting this option to enabled will allow the hub LED to operate properly | ||
|
CABLE TYPE | ||
|
Type |
JP6 | |
|
Software select |
Pins 1 & 2 closed | |
|
RG58A/U 50ohm coaxial |
Pins 2 & 3 closed | |
|
ONBOARD TERMINATOR | ||
|
Setting |
JP7 | |
|
Disabled |
Pins 2 & 3 closed | |
|
Enabled |
Pins 1 & 2 closed | |
|
Note:When using RG58A/U 50ohm coaxial cable the onboard 50ohm terminator may be used instead of using a T-connector and an external terminator. | ||
|
DIAGNOSTIC LED(S) | ||
|
LED |
Status |
Condition |
|
LED1 |
On |
Data is being transmitted |
|
LED1 |
Off |
Data is not being transmitted |
|
LED2 |
On |
Twisted pair connection is good |
|
LED2 |
Off |
Twisted pair connection is broken |
|
LED3 |
On |
Data is being received |
|
LED3 |
Off |
Data is not being received |
|
LED4 |
On |
Collision detected on network |
|
LED4 |
Off |
No collisions detected on network |
|
FACTORY CONFIGURED SETTINGS | |
|
Jumper |
Setting |
|
JP2 |
Unused |
|
JP3 |
Unused |
|
JP4 |
Unused |
|
JP5 |
Unused |