ARTISOFT, INC.
AE-2/C ETHERNET ADAPTER
|
NIC Type |
Ethernet |
|
Transfer Rate |
10Mbps |
|
Data Bus |
16-bit ISA |
|
Topology |
Linear Bus |
|
Wiring Type |
RG-58A/U, RG-58C/U, Belden 9907, & Belden 89907 50ohm coaxial AUI transceiver via DB-15 Port |
|
Boot ROM |
Available |
|
INTERRUPT REQUEST | |||||||||
|
IRQ |
W1A |
W1B |
W1C |
W1D |
W1E |
W1F |
W1G |
W1H | |
|
2/9 |
Closed |
Open |
Open |
Open |
Open |
Open |
Open |
Open | |
|
3 |
Open |
Closed |
Open |
Open |
Open |
Open |
Open |
Open | |
|
4 |
Open |
Open |
Closed |
Open |
Open |
Open |
Open |
Open | |
|
5 |
Open |
Open |
Open |
Closed |
Open |
Open |
Open |
Open | |
|
6 |
Open |
Open |
Open |
Open |
Closed |
Open |
Open |
Open | |
|
7 |
Open |
Open |
Open |
Open |
Open |
Closed |
Open |
Open | |
|
10 |
Open |
Open |
Open |
Open |
Open |
Open |
Closed |
Open | |
|
15 |
Open |
Open |
Open |
Open |
Open |
Open |
Open |
Closed | |
|
DMA CHANNEL | |||||
|
Channel |
W4A |
W4B |
W4C |
W4D | |
|
Disabled |
Open |
Open |
Open |
Open | |
|
DMA1 |
Closed |
Open |
Open |
Open | |
|
DMA3 |
Open |
Closed |
Open |
Open | |
|
DMA5 |
Open |
Open |
Closed |
Open | |
|
DMA7 |
Open |
Open |
Open |
Closed | |
|
I/O BASE ADDRESS | |||||
|
Address |
W5E |
W5F |
W5G |
W5H | |
|
300h |
Closed |
Closed |
Open |
Open | |
|
320h |
Closed |
Open |
Closed |
Open | |
|
340h |
Open |
Closed |
Open |
Closed | |
|
360h |
Open |
Open |
Closed |
Closed | |
|
NOVELL EMULATION | |||
|
Setting |
W5A |
W5B | |
|
Normal mode |
Open |
Closed | |
|
NE2000 Emulation mode |
Closed |
Open | |
|
Note:When set in Novell Emulation, adapter will still be compatible with LANtastic Network operating
| |||
|
DATA BUS SIZE | |||
|
Setting |
W5C |
W5D | |
|
Automatic select |
Open |
Closed | |
|
Force 8-Bit mode |
Closed |
Open | |
|
Note:When in automatic mode, the card will sense the size of slot in which it is installed and configure
| |||
|
BOOT ROM | ||
|
Setting |
W6A | |
|
Disabled |
Open | |
|
Enabled |
Closed | |
|
BOOT ROM SIZE | |||
|
Size |
W6F |
W6G | |
|
8KB |
Closed |
Open | |
|
16KB |
Open |
Closed | |
|
32KB |
Open |
Open | |
|
BOOT ROM ADDRESS (8KB ROM) | ||||
|
Address |
W6B |
W6C |
W6D |
W6E |
|
C8000h |
Open |
Open |
Open |
Open |
|
CC000h |
Closed |
Open |
Open |
Open |
|
D0000h |
Open |
Closed |
Open |
Open |
|
D4000h |
Closed |
Closed |
Open |
Open |
|
D8000h |
Open |
Open |
Closed |
Open |
|
DC000h |
Closed |
Open |
Closed |
Open |
|
E0000h |
Open |
Closed |
Closed |
Open |
|
BOOT ROM ADDRESS (32KB ROM) | |||||
|
Address |
W6B |
W6C |
W6D |
W6E | |
|
C0000h |
Open |
Open |
Open |
Open | |
|
C8000h |
Closed |
Open |
Open |
Open | |
|
D0000h |
Open |
Closed |
Open |
Open | |
|
D8000h |
Closed |
Closed |
Open |
Open | |
|
E0000h |
Open |
Open |
Closed |
Open | |
|
E8000h |
Closed |
Open |
Closed |
Open | |
|
BOOT ROM ADDRESS (16KB ROM) | ||||
|
Address |
W6B |
W6C |
W6D |
W6E |
|
C0000h |
Open |
Open |
Open |
Open |
|
C4000h |
Closed |
Open |
Open |
Open |
|
C8000h |
Open |
Closed |
Open |
Open |
|
CC000h |
Closed |
Closed |
Open |
Open |
|
D0000h |
Open |
Open |
Closed |
Open |
|
D4000h |
Closed |
Open |
Closed |
Open |
|
D8000h |
Open |
Closed |
Closed |
Open |
|
DC000h |
Closed |
Closed |
Closed |
Open |
|
E0000h |
Open |
Open |
Open |
Closed |
|
E4000h |
Closed |
Open |
Open |
Closed |
|
E8000h |
Open |
Closed |
Open |
Closed |
|
EC000h |
Closed |
Closed |
Open |
Closed |
|
BOOT ROM CHIP TYPE | ||
|
Type |
W6H | |
|
Standard ROM or Novell boot ROM |
Open | |
|
EPROM |
Closed | |
|
THIN-NET SEGMENT LENGTH | ||
|
Length |
W7 | |
|
185 Meters |
Pins 1 & 2 Closed | |
|
300 Meters |
Pins 2 & 3 Closed | |
|
Note:If 300 meters is enabled, the network must consist of only one single segment. There can be no hubs or repeaters. All adapters in the network must be set for the same segment length. In setting this jumper to 300 meters, the adapter will not be in compliance with the IEEE 802.3 standard. | ||
|
BUS TIMING SELECTION | ||
|
Type |
W8 | |
|
Standard |
Pins 1 & 2 Closed | |
|
Non-Standard |
Pins 2 & 3 Closed | |
|
Note:Early Chips & Technologies chip sets, Toshiba 5200 laptops, and others, have incompatible bus timing. If your PC locks up during boot, try enabling the Non-Standard Bus type. | ||
|
CABLE TYPE | ||
|
Type |
W10 | |
|
Coaxial |
Pins 2 & 3 Closed | |
|
AUI Transceiver via DB-15 Port |
Pins 1 & 2 Closed | |
|
Note:The following are the only types of cable that Artisoft supports: For Coaxial: RG-58A/U 50ohm, RG-58C/U, Belden 9907, Belden 89907 For AUI transceiver via DB-15 port: Belden 9880 | ||