PATTON ELECTRONICS COMPANY
2085
|
Card Type |
Interface Converter |
|
Chip Set |
Unidentified |
|
I/O Options |
25-pin serial port (RS-232), network interface via RJ-45, RJ-11, 25-pin port or terminal block |
|
Wiring Type |
Unshielded twisted pair |
|
Maximum Data Rate |
115.2Kbps |
|
Data Bus |
External |
|
CONNECTIONS | |||
|
Function |
Label |
Function |
Label |
|
DTE/DCE serial port (25-pin connector) |
CN1 |
UTP interface |
CN2 |
|
Note: Network interface (CN2) is available with several connector options. Device may feature a terminal block, RJ-11, RJ-45, or 25-pin (male or female) connector. | |||
|
USER CONFIGURABLE SETTINGS | ||
|
Setting |
Label |
Position |
|
DTE mode |
S2 |
On |
|
DCE mode |
S2 |
Off |
|
USER CONFIGURABLE SETTINGS | |||
|
Setting |
Label |
Position | |
|
8ms RTS/CTS delay enabled |
S1/3 |
On | |
|
RTS/CTS delay disabled |
S1/3 |
Off | |
|
Echo mode disabled |
S1/4 |
Off | |
|
Echo mode enabled |
S1/4 |
On | |
|
Carrier controlled by RTS |
S1/5 |
On | |
|
Carrier forced high |
S1/5 |
Off | |
|
Receive impedance set low (120Ohms) |
S1/6 |
On | |
|
Receive impedance set high (16kOhms) |
S1/6 |
Off | |
|
TRANSMIT LINE IMPEDENCE | |||
|
Setting |
S1/1 |
S1/2 | |
|
High impedence enabled |
Off |
Off | |
|
Intermediate impedence enabled |
On |
On | |
|
2-WIRE/4-WIRE MODE SELECTION | |||
|
Setting |
S1/7 |
S1/8 | |
|
2-wire mode enabled |
On |
On | |
|
4-wire mode enabled enabled |
Off |
Off | |