PATTON ELECTRONICS COMPANY
2070/CX
|
Card Type |
Interface Converter |
|
Chip Set |
Unidentified |
|
I/O Options |
V.35 DCE port, RJ-45 twisted pair interface, power |
|
Maximum Data Rate |
64Kbps |
|
Data Bus |
External |
|
CONNECTIONS | |||
|
Function |
Label |
Function |
Label |
|
V.35 DCE port (34-pin male connector) |
CN1 |
UTP interface (RJ-45 connector) |
CN2 |
|
Power |
CN3 | ||
|
USER CONFIGURABLE SETTINGS | |||
|
Setting |
Label |
Position | |
|
Local line loopback and G.703 loop diagnostics disabled |
S1/1 |
Off | |
|
Local line loopback and G.703 loop diagnostics enabled |
S1/1 |
On | |
|
Ignores local loopback requests |
S1/4 |
On | |
|
Enters local loopback mode when pin 18 is raised |
S1/4 |
Off | |
|
AC power enabled |
JP1 |
Pins 1 & 3 closed | |
|
Interface power enabled |
JP1 |
Pins 1 & 2 closed | |
|
Signal ground is connected to frame ground |
JP1 |
Pins 5 & 6 closed | |
|
Signal ground is disconnected from frame ground |
JP1 |
Pins 4 & 6 closed | |
|
CLOCK SOURCE | |||
|
Setting |
S1/2 |
S1/3 | |
|
Terminal timing supplied by network signal |
On |
Off | |
|
Terminal timing supplied by DTE device |
On |
Off | |
|
Transmit clock generated internally |
Off |
On | |
|
DIAGNOSTIC LED(S) | |||
|
LED |
Color |
Status |
Condition |
|
SYNC |
Green |
On |
Valid synchronization to the terminal device exists |
|
SYNC |
Green |
Off |
Synchronization has slipped, or connection is broken |
|
TM |
Red |
On |
Device is conducting a loopback test |
|
TM |
Red |
Off |
Device is not conducting a loopback test |