WESTERN DIGITAL CORPORATION
WD1007A-WA4
Data Bus |
16-bit |
Card Size |
Full-length, full-height card |
Hard Drives supported |
Two ESDI drives |
Sector Interleave |
1:1 |
Floppy drives supported |
Two 360KB or 720KB drives |
CONNECTIONS | |||
Function |
Function | ||
4-pin connector-drive active LED |
J1 |
34-pin data cable connector-floppy drive |
J5 |
20-pin data cable connector-drive 1 |
J2 |
9-pin serial port - external |
J6 |
20-pin data cable connector-drive 0 |
J3 |
25-pin parallel port - external |
J7 |
34-pin data cable connector-controller board |
J4 |
|
|
USER CONFIGURABLE SETTINGS | |||
Function |
Label |
Position | |
Primary floppy address 3FX |
W1/pins 1 & 2 |
closed | |
Floppy controller disabled |
W1/pins 2 & 3 |
closed | |
Secondary floppy address 37X |
W1/pins 3 & 4 |
closed | |
Primary hard disk address 1FX |
W2/pins 1 & 2 |
closed | |
Secondary hard disk address 17X |
W2/pins 2 & 3 |
closed | |
Primary parallel port address 37X |
W3/pins 1 & 2 |
closed | |
Parallel port disabled |
W3/pins 2 & 3 |
closed | |
Secondary port address 27X |
W3/pins 3 & 4 |
closed | |
Primary serial port address 3FX |
W4/pins 1 & 2 |
closed | |
Serial port disabled |
W4/pins 2 & 3 |
closed | |
Secondary serial port address 2FX |
W4/pins 3 & 4 |
closed | |
Digital input register, non-latched |
W9 |
open | |
Digital input register, latched |
W9 |
closed | |
WD 1007 mode |
W16/pins 1 & 2 |
open | |
WD 1005 mode |
W16/pins 1 & 2 |
closed | |
Translation enabled |
W16/pins 3 & 4 |
open | |
Translation disabled |
W16/pins 3 & 4 |
closed | |
ECC correction, 4 bytes |
W16/pins 5 & 6 |
open | |
ECC correction, 7 bytes |
W16/pins 5 & 6 |
closed |
BIOS ADDRESS SELECTION | ||||
Address |
W13 |
W14 |
W15 | |
C8000h-C9FFFh |
N/A |
Pins 2 & 3 closed |
Pins 2 & 3 closed | |
CA000-CBFFFh |
N/A |
Pins 2 & 3 closed |
Pins 1 & 2 closed | |
CC000-CDFFFh |
N/A |
Pins 1 & 2 closed |
Pins 2 & 3 closed | |
CE00-CFFFh |
Closed |
Pins 1 & 2 closed |
Pins 1 & 2 closed | |
BIOS disabled |
Open |
N/A |
N/A |
MISCELLANEOUS TECHNICAL NOTES |
Note: This controller has a built-in low-level format program. To enter the program, run the BIOS routine through the DOS DEBUG utility and at the prompt enter: G=C800:5. |