UNIDENTIFIED
FD/HD/TD Controller
|
Data bus: 16-bit,ISA
Size: Half-length, half-height card
Hard drives supported: Two MFM ST506 drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, 1.44MB
Sector interleave: 1:1
CONNECTIONS | |
Function |
Location |
34-pin control cable connector-floppy drive |
J1 |
50-pin control cable connector-tape drive |
J2 |
20-pin data cable connector-drive 0 |
J3 |
20-pin data cable connector-drive 1 |
J4 |
34-pin control cable connector-hard drive |
J5 |
2-pin connector-drive active LED |
J6 |
TAPE DRIVE I/O PORT ADDRESS | ||||
Address |
Jumper W4 |
Jumper W5 |
Jumper W6 | |
208h |
pins 2 & 3 closed |
pins 1 & 2 closed |
pins 1 & 2 closed | |
108h |
pins 1 & 2 closed |
pins 2 & 3 closed |
pins 1 & 2 closed | |
218h |
pins 2 & 3 closed |
pins 1 & 2 closed |
pins 2 & 3 closed | |
118h |
pins 1 & 2 closed |
pins 2 & 3 closed |
pins 2 & 3 closed |
USER CONFIGURABLE SETTINGS | |||
Function |
Location |
Setting | |
Reserved for Phase Lock Loop Feedback circuit |
W1 |
pins 1 & 2 closed | |
Reserved for Read Gate |
W1 |
pins 1 & 2 closed | |
Floppy drive port address is 3F0-3F7h |
W7 |
pins 2 & 3 closed | |
Floppy drive port address is 370-377h |
W7 |
pins 1 & 2 closed | |
Hard drive port address is 1F0-1F7h |
W8 |
pins 2 & 3 closed | |
Hard drive port address is 170-177h |
W8 |
pins 1 & 2 closed | |
Reserved for Read Data Window |
W9 |
pins 1 & 2 closed | |
Reserved for Read Data Window |
W10 |
pins 1 & 2 closed | |
Frame ground and signal ground |
W11 |
pins 1 & 2 closed | |
Frame ground and signal ground |
W12 |
pins 1 & 2 closed |
INTERRUPT REQUEST | |||||
IRQ |
SW1/switch 1 |
SW1/switch 2 |
SW1/switch 3 |
SW1/switch 4 | |
IRQ10 |
on |
off |
off |
off | |
IRQ11 |
off |
on |
off |
off | |
IRQ12 |
off |
off |
on |
off | |
IRQ15 |
off |
off |
off |
on |
DMA CHANNEL | ||||
Channel |
SW1/switch 5 and 8 |
SW1/switch 6 and 9 |
SW1/switch 7 and 10 | |
DRQ5 |
on |
off |
off | |
DRQ6 |
off |
on |
off | |
DRQ7 |
off |
off |
on |