TEKRAM TECHNOLOGY CO., LTD.
DC-600T
|
| |
|
Data bus: |
16-bit, ISA |
|
Size: |
Three/quarter-length, full-height card |
|
Hard drive supported: |
Four IDE (AT) Interface drives |
|
Floppy drives supported: |
Two 360KB, 720KB, 1.2MB, or 1.44MB drives |
|
CONNECTIONS | |
|
Function |
Location |
|
40-pin IDE (AT) Interface connector - IDE-0 |
CN1 |
|
40-pin IDE (AT) Interface connector - IDE-1 |
CN2 |
|
34-pin control cable connector - floppy drive |
CN3 |
|
4-pin connector - drive active LED |
JP1 |
|
4-pin connector - cache error speaker |
JP2 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
IDE-0 damping resistor enabled |
JDR0 |
open | |
|
IDE-0 damping resistor disabled |
JDR0 |
closed | |
|
IDE-1 damping resistor enabled |
JDR1 |
open | |
|
IDE-1 damping resistor disabled |
JDR1 |
closed | |
|
BIOS ADDRESS | ||||
|
Address |
JP3/jumper 1 |
JP3/jumper 2 |
JP3/jumper 3 | |
|
DC000h |
closed |
closed |
closed | |
|
DC000h |
closed |
closed |
open | |
|
D8000h |
closed |
open |
closed | |
|
D4000h |
closed |
open |
open | |
|
D0000h |
open |
closed |
closed | |
|
CC000h |
open |
closed |
open | |
|
C8000h |
open |
open |
closed | |
|
Disabled |
open |
open |
open | |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
Floppy drive enabled |
JP3/jumper 4 |
closed | |
|
Floppy drive disabled |
JP3/jumper 4 |
open | |
|
Hard drive port address is 1F0-1F7h |
JP3/jumper 5 |
closed | |
|
Hard drive port address is 170-177h |
JP3/jumper 5 |
open | |
|
MISCELLANEOUS TECHNICAL NOTES |
|
At least one SIMM memory module (256KB, 1MB, or 4MB) must be installed in order for the controller to function. Different sizes can be mixed in any combination. |