MYLEX CORPORATION
DAC960E
|
Data bus: |
32-bit EISA |
|
Size: |
Three-quarter length, full-height card |
|
Hard drive supported: |
Up to twenty-one Fast SCSI-2 devices |
|
Floppy drives supported: |
None |
|
CONNECTIONS | |
|
Function |
Location |
|
50-pin SCSI channel 2 connector - internal |
J2 |
|
50-pin SCSI channel 1 connector - internal |
J3 |
|
50-pin SCSI channel 0 connector - internal |
J4 |
|
50-pin SCSI channel 0 connector - external |
J6 |
|
2-pin connector - SCSI active LED |
JP1/pins 1 & 2 |
|
2-pin connector - EISA active LED |
JP1/pins 3 & 4 |
|
2-pin connector - write pending LED |
JP1/pins 5 & 6 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
Factory configured - do not alter |
JP2 |
N/A | |
|
Termination power enabled for SCSI channel 2 |
JP3 |
Closed | |
|
Termination power disabled for SCSI channel 2 |
JP3 |
Open | |
|
Termination power enabled for SCSI channel 1 |
JP4 |
Closed | |
|
Termination power disabled for SCSI channel 1 |
JP4 |
Open | |
|
Termination power enabled for SCSI channel 0 |
JP5 |
Closed | |
|
Termination power disabled for SCSI channel 0 |
JP5 |
Open | |
|
Note: Enable termination power when the controller is installed at one end of a channel and disable termination power when a channel is not at the end of SCSI cable. When both connectors J4 and J6 use channel 0, disable termination to that channel. | |||
|
DRAM CONFIGURATION | |
|
Size |
Bank 0 |
|
2MB |
(1) 512 x 36 |
|
4MB |
(1) 1M x 36 |
|
8MB |
(1) 2M x 36 |
|
16MB |
(1) 4M x 36 |
|
32MB |
(1) 8M x 36 |