INITIO CORPORATION
INI-9400U/UW
|
Card Type |
Hard drive controller |
|
Data Bus |
32-bit PCI |
|
Card Size |
Quarter-length, full-height card |
|
Hard Drives supported |
Up to 60 Ultra or Ultra Wide SCSI devices |
|
Floppy drives supported |
None |
|
CONNECTIONS | |||
|
Function |
Location |
Function |
Location |
|
50-pin SCSI connector channel 0 - internal |
J1 |
50-pin SCSI connector channel 2 - internal |
J7 |
|
4-pin connector - drive active LED |
J2 |
Drive active LED |
J8 |
|
68-pin SCSI connector - external |
J3 |
68-pin SCSI connector channel 2 - internal |
J9 |
|
50-pin SCSI connector channel 1 - internal |
J4 |
50-pin SCSI connector channel 3 - internal |
J10 |
|
Drive active LED |
J5 |
Drive active LED |
J11 |
|
68-pin SCSI connector channel 1 - internal |
J6 |
68-pin SCSI connector channel 3 - internal |
J12 |
|
TERMINATION CONFIGURATION FOR MULTIPLE INITIATORS |
|
Note: Jumpers JP1, JP2, JP3, and JP4 set active termination on each specific SCSI bus so it is always on. The setting is used only when the adapter shares the SCSI bus with an adapter in another computer. If this computer can be turned off, closing the jumper will insure that active on-board termination is on all the time, regardless of whether power is applied or not. |