KOUWELL ELECTRONICS CORPORATION
KW-801
|
Data Bus |
32-bit PCI |
|
Card Size |
Half-height, half-length card |
|
Hard Drives supported |
Up to 7 SCSI-2 devices |
|
Floppy drives supported |
None |
|
CONNECTIONS | |||
|
Function |
Location |
Function |
Location |
|
50-pin SCSI connector - internal |
J1 |
2-pin connector - drive active LED |
J4 |
|
50-pin SCSI connector - external |
J2 |
|
|
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Label |
Position | |
|
Active termination enabled |
JP1 |
Closed | |
|
Active termination disabled |
JP1 |
Open | |
|
Note: When BOTH external AND internal devices exist, disable on-board termination jumper JP1 and insert the resister array RP1-RP3. This setting is used if controller lies within the device chain. When only external devices OR only internal devices exist, enable JP1 and remove resister arry RP1-RP3. This setting is used when controller is at one end of device chain. (Location of resistors RP1-RP3 is unidentified.) | |||
|
PCI INTERRUPT SELECTION | |||
|
Setting |
JP2 |
JP3 | |
|
INTA |
Pins 2 & 3 closed |
Open | |
|
INTB |
Pins 1 & 2 closed |
Open | |
|
INTC |
Open |
Pins 2 & 3 closed | |
|
INTD |
Open |
Pins 1 & 2 closed | |