CMD TECHNOLOGY, INC.
CSA-6400E
|
Card Type |
Hard drive controller |
|
Hard Drives supported |
Four IDE (AT) drives |
|
Floppy drives supported |
None |
|
Data Bus |
32-bit PCI |
|
Card Size |
Half length, full-height |
|
CONNECTIONS | |||
|
Function |
Location |
Function |
Location |
|
40-pin secondary IDE(AT) connector |
CN1 |
Drive active LED |
CN3 |
|
40-pin primary IDE(AT) connector |
CN2 |
Paddle board connector |
CN4 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Label |
Position | |
|
DskChg (removable media) disabled |
W2/1 |
Open | |
|
DskChg (removable media) enabled |
W2/1 |
Closed | |
|
Base address enabled |
W2/2 |
Closed | |
|
Base address disabled |
W2/2 |
Open | |
|
PCI chip enabled |
W2/3 |
Open | |
|
PCI chip disabled |
W2/3 |
Closed | |
|
Factory configured - do not alter |
W3/ 1 - 4 |
Open | |
|
Factory configured - do not alter |
W4/ 1 - 4 |
Open | |
|
Factory configured - do not alter |
W5 |
Open | |
|
Normal base addressing (Legacy mode) enabled |
W6/pins 2 & 3 |
Closed | |
|
Normal base addressing (Legacy mode) enabled |
W7/pins 2 & 3 |
Closed | |
|
Note:W6 & W7 pins 1 & 2 positions are not used. | |||