DATA TECHNOLOGY CORPORATION
DTC2132D
|
| |
|
Data bus: |
32-bit PCI |
|
Size: |
Half-length, half-height card |
|
Hard drive supported: |
Four IDE(AT) or EIDE interface drives |
|
Floppy drives supported: |
None |
|
CONNECTIONS | |
|
Function |
Location |
|
10-pin DTC-1415 ISA B Interrupt adapter connector |
J1 |
|
4-pin connector - drive active LED |
J2 |
|
40-pin connector - primary IDE(AT) interface |
J3 |
|
40-pin connector - secondary IDE(AT) interface |
J4 |
|
Note: Connector J1 is intended for use in systems that do not support redirected PCI interrupts. | |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
Primary port INTA redirect to IRQ14 |
W1/pins 1 & 3 |
closed | |
|
Primary port INTB redirect to IRQ14 |
W1/pins 2 & 4 |
closed | |
|
Primary port INTC redirect to IRQ14 |
W1/pins 3 & 5 |
closed | |
|
Primary port INTD redirect to IRQ14 |
W1/pins 4 & 6 |
closed | |
|
Secondary port INTA redirect to IRQ15, IRQ12 or IRQ11 |
W2/pins 1 & 3 |
closed | |
|
Secondary port INTB redirect to IRQ15, IRQ12 or IRQ11 |
W2/pins 2 & 4 |
closed | |
|
Secondary port INTC redirect to IRQ15, IRQ12 or IRQ11 |
W2/pins 3 & 5 |
closed | |
|
Secondary port INTD redirect to IRQ15, IRQ12 or IRQ11 |
W2/pins 4 & 6 |
closed | |
|
Fixed IDE address at power-up (1F0-1F7h) |
W3 |
closed | |
|
Relocatable IDE address at power-up |
W3 |
open | |
|
IDE decode state disabled after reset |
W4 |
closed | |
|
IDE decode state enabled after reset |
W4 |
open | |