DATA TECHNOLOGY CORPORATION
DTC 2130 (900148-89B)
|
Data bus: |
32-bit PCI |
|
Size: |
Full-length, full-height card |
|
Hard drive supported: |
Two IDE(AT) Interface drives |
|
Floppy drives supported: |
None |
|
CONNECTIONS | |
|
Function |
Location |
|
10-pin connector - header cable connection |
J1 |
|
40-pin connector - IDE interface |
J2 |
|
Drive activity LED |
LED |
|
USER CONFIGURABLE SETTINGS | ||
|
Function |
Location |
Setting |
|
PCI INTA redirected to IRQ14 |
W1 |
closed |
|
PCI INTA not able to be redirected to IRQ14 |
W1 |
open |
|
MISCELLANEOUS TECHNICAL NOTE |
|
Note:If your motherboard has an on-board IDE controller, it will have to be disabled. The DTC 2130S |
|
needs access to IRQ14 in order to operate properly in the PCI slot. Some motherboards allow you redirect PCI INTA to IRQ14. If the PCI motherboard wont allow you to redirect PCI interrrupts, then you will need to use the DTC 1415 Interrupt adapter. The DTC 1415 installs into any ISA B slot and has a header (W1) compatible with the DTC 2130S J1 header. The ISA A slot may still be used by an 8-bit card. |