ACCULOGIC, INC.
ISAPPORT
|
| |
|
Data bus: |
16-bit ISA |
|
Size: |
Half-length, full-height card |
|
Hard drive supported: |
Up to seven Fast SCSI-2 devices |
|
Floppy drives supported: |
Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives |
|
CONNECTIONS | |
|
Function |
Location |
|
50-pin SCSI connector - external |
J1 |
|
50-pin SCSI connector - internal |
J2 |
|
34-pin cable connector - floppy drive |
J3 |
|
4-pin power connector |
J8 |
|
4-pin connector - drive active LED |
J9 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
Floppy drive interface enabled as primary |
JP2 |
Pins 2 & 3 closed | |
|
Floppy drive interface disabled |
JP2 |
Pins 1 & 2 closed | |
|
Normally configure board during installation |
SW1 |
Position 2 | |
|
Lock configuration during installation |
SW1 |
Position 1 | |
|
Reset configuration |
SW1 |
Position 3 | |
|
Note: SW1 is set to normal unless two ISApport boards are installed on the same system. In this situation, the boards are installed sequentially. First, board 1 is installed and configured. Then, its SW1 is set to lock, and board 2 is installed and configured with its SW1 set to normal. The reset setting for SW1 is not identified. | |||