ALPHA DESIGN
AD-102V
|
| |
|
Data bus: |
16-bit ISA |
|
Size: |
Three-quarter length, Full-height card |
|
Hard drive supported: |
Two IDE(AT) interface drives |
|
Floppy drives supported: |
360KB, 720KB, 1.2MB, 1.44MB |
|
CONNECTIONS | |
|
Function |
Location |
|
34-pin control cable connector - floppy drive |
J1 |
|
20-pin data cable connector - drive 1 |
J3 |
|
20-pin data cable connector - drive 0 |
J4 |
|
34-pin control cable connector - hard drive |
J5 |
|
4-pin connector - drive active LED |
J6 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
Controller is incompatible with WD1003-WA2 |
W2 |
open | |
|
Controller is compatible with WD1003-WA2 |
W2 |
closed | |
|
Hard drives in latched mode |
W3 |
open | |
|
Hard drives in non-latched mode |
W3 |
closed | |
|
Caching enabled |
W4 |
open | |
|
Caching disabled |
W4 |
closed | |
|
USER CONFIGURABLE SETTINGS(CONTINUED) | |||
|
Function |
Location |
Setting | |
|
4-byte ECC enabled |
W5 |
open | |
|
7-byte ECC enabled |
W5 |
closed | |
|
Hard drive primary address select |
W6 |
open | |
|
Hard drive alternate address select |
W6 |
closed | |
|
Floppy drive interface primary address select |
W7 |
open | |
|
Floppy drive interface alternate address select |
W7 |
closed | |
|
Factory configured - do not alter |
W8 |
N/A | |
|
Single speed floppy drive supported |
W17 |
open | |
|
Dual speed floppy drive supported |
W17 |
closed | |
|
Mounting bracket not grounded |
W18 |
open | |
|
Mounting bracket grounded |
W18 |
closed | |