UNIDENTIFIED
GW-106V/GW-106V1
|
| |
|
Data bus: |
16-bit ISA |
|
Size: |
Three-quarter length, full-height card |
|
Hard drive supported: |
Two ST506/412 drives |
|
Floppy drives supported: |
360KB, 720KB, 1.2MB, 1.44MB |
|
CONNECTIONS | |
|
Function |
Location |
|
34-pin control cable connector - floppy drive |
J1 |
|
20-pin data cable connector - drive 1 |
J3 |
|
20-pin data cable connector - drive 0 |
J4 |
|
34-pin control cable connector - hard drive |
J5 |
|
4-pin connector - drive active LED |
JP1 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
Latched hard drive mode enabled |
JP2/A |
open | |
|
Non-latched hard rive mode enabled |
JP2/A |
closed | |
|
Four byte ECC enabled |
JP2/B |
open | |
|
Reserved |
JP2/B |
closed | |
|
Caching enabled |
JP2/C |
open | |
|
Caching disabled |
JP2/C |
closed | |
|
Factory configured - do not alter |
JP2/D |
N/A | |
|
Floppy drive interface primary address select |
JP3 |
open | |
|
Floppy drive interface alternate address select |
JP3 |
closed | |
|
USER CONFIGURABLE SETTINGS(CONTINUED) | |||
|
Function |
Location |
Setting | |
|
Hard drive interface primary address select |
JP4 |
open | |
|
Hard drive interface alternate address select |
JP4 |
closed | |
|
Bracket ground disabled |
JP5 |
open | |
|
Bracket ground enabled |
JP5 |
closed | |
|
Floppy drive interface single speed enabled |
JP6 |
open | |
|
Floppy drive interface dual speed enabled |
JP6 |
closed | |
|
Note: The location of jumper JP5 is unspecified in manufacturer documentation. | |||