PROCOMP USA, INC.
PM-171 (PRO-MASTER)
|
Data Bus |
32-bit EISA |
|
Card Size |
Full-height, Half-length |
|
Hard Drives supported |
Up to 7 SCSI-2 devices |
|
Floppy drives supported |
Two 360KB, 720KB, 1.2MB, or 1.44MB drives |
|
CONNECTIONS | |||
|
Function |
Location |
Function |
Location |
|
50-pin SCSI connector - external |
P1 |
4-pin connector - drive active LED |
P4 |
|
34-pin cable connector - floppy drive |
P2 |
UPS jack (only on some models) |
P5 |
|
50-pin SCSI connector - internal |
P3 | ||
|
FLOPPY CONTROLLER CONFIGURATION | ||||
|
Setting |
JP2/Pins 1 & 2 |
JP2/Pins 3 & 4 |
JP2/Pins 5 & 6 | |
|
Enabled by hardware |
Closed |
Open |
Open | |
|
Configured by EISA configuration utility |
Open |
Closed |
Open | |
|
Disabled by hardware |
Open |
Open |
Closed | |
|
USER CONFIGURABLE SETTINGS | |||
|
Setting |
JP1 | ||
|
Termpower supplied by adapter to SCSI bus enabled |
Pins 1 & 2 closed | ||
|
Termpower supplied by adapter to SCSI bus disabled |
Pins 2 & 3 closed | ||
|
Notes: On the board, JP1/pins 1 & 2 correspond to the "ON to center-pin" position; JP1/pins 2 & 3 correspond to the "center-pin to OFF" position. | |||